Phone: 1-800-726-8367 | Email: [email protected]

BioKnit® Conductive Glove

The conductive fabric properties of the BioKnit® conductive garments and pads take the place of traditional adhesive electrodes when used in conjunction with an electrical stimulation device such as TENS, EMS or HVPS. The electrodes used in these garments are woven with silver thread to provide even stimulation to the entire covered area and cover hard-to-reach areas, such as the back and shoulder. This is a great alternative for patients with skin too sensitive for traditional adhesive electrodes.

BioKnit® conductive garment are reusable, hand washable and are for single patient use only.

An Electrolyte Spray is recommended for all our conductive garments. Electrolyte sprays increase electrode-to-skin conductivity, helps to eliminate hot spots and prevents electrode dry-out during prolonged use. Electrolyte Spray also help to coat the silver conductive thread preventing tarnish that water and other media may cause.

is always recommended for all our conductive garments. An Electrolyte Spray increases electrode-to-skin conductivity, helps to eliminate hot spots and prevents electrode dry-out during prolonged use. Our Electrolyte Spray also helps to coat the silver conductive thread preventing tarnish that water and other media may cause.

Conductive Garment benefits include:

  • Covers Hard to Reach Areas
  • Great for Patients with Skin Conditions
  • Stimulates beneath a Cast
  • Covers Large Areas or Multiple Sites
  • Reusable
  • Hand Washable
  • Conductive Garments are perfect for patients suffering from arthritis, neuropathy, carpel tunnel, tennis elbow, ACL/MCL knee injuries, shoulder pain, low back pain and other conditions!

HCPCS code # E0731

Sold only through authorized distributors

 

Categories: , Tags: ,
General Instructions for use

General Instructions for use

#GAR111

SM/MED Conductive Glove – fits 6.5” to 12” circumference around knuckles.

 

#GAR112

LRG/XL Conductive Glove – fits 9″ to 16″ circumference around knuckles.

 

How to use

How to use

  • GENERAL INSTRUCTIONS FOR USE
    1. Remove all jewelry from any are of the body to be treated.
    2. Clean the area to be treated thoroughly with soap and water. It is OK to leave the skin wet or moist when applying your Conductive Garment. Apply an Electrolyte Spray on each conductive pad. Also, lightly spray & rub Electrolyte Spray into skin.

    (if using a conductive glove, sock, or sleeve read additional bullet information below, otherwise proceed to #3.)

    • (glove, sock, or sleeve only) Cover treatment are with the glove, sleeve, or sock as directed by your health care professional.
    • (glove, sock, or sleeve only) Place a second electrode garment or sticky electrode as directed by your health care professional.
    1. Take one set of wires from the approved electro-stimulation device you are using and attach one end to each electrode.
    2. You can now apply stimulation from the electro stimulation device as directed by your health care professional.
    3. Upon completion of the treatment, place garment back into resalable bag.

    IMPORTANT

    1. You can hand wash your conductive garment in cold water using soap designed for washing delicate fabrics. Rinse thoroughly. Carefully block into shape on a towel and allow to air dry. Do not place in dryer.
    2. Do not apply to broken skin (open wound).
    3. Garment electrodes can use either positive of negative polarity.
    4. No stimulation should be applied while operating a motor vehicle or machinery.
    5. Should treatment cause any skin rash, consult your health care professional.

    CAUTION

    Federal law restricts this device to sale by or on the order of a licensed health care practitioner.

Related Products